Brake Systems and Axles

Braking Systems

Braking Systems

The brake system is actually composed of two kinds of systems---Hydraulics and Friction Materials. Here's what happens within these systems between the time your foot hits the brake pedal and your car stops.

Hydraulics

Master Cylinder
When pressure is applied to the brake pedal, the master cylinder creates hydraulic pressure which pushes brake fluid to the wheel brakes.

Brake Lines and Hoses
Steel brake lines and high pressure rubber hoses are the avenues through which the pressurized brake fluid travels.

Wheel Cylinders and Calipers
These are the hydraulic cylinders that apply pressure to the friction materials, causing your car to stop.

Friction Materials

Disc Brake Pads and Drum Brake Shoes
These brake linings are composed of high temperature materials that create the friction that stops your car.

Types of Brakes

Disc Brakes
Disc brakes consist of a Disc Brake Rotor, which is attached to the wheel, and a Caliper, which holds the Disc Brake Pads. Hydraulic pressure from the Master Cylinder causes the Caliper Piston to clamp the Disc Brake Rotor between the Disc Brake Pads. This creates friction between the pads and rotor, causing your car to slow down or stop.

Drum Brakes
Drum brakes consist of a Brake Drum attached to the wheel, a Wheel Cylinder, Brake Shoes and Brake Return Springs. Hydraulic pressure from the Master Cylinder causes the Wheel Cylinder to press the Brake Shoes against the Brake Drum. This creates friction between the shoes and drum to slow or stop your car.

Parking Brake
The Parking Brake uses Cables to mechanically apply the brakes (usually the rear brake.) This is used to prevent the car from rolling when not being driven.

Anti-Lock Brakes: A System Built For Safety
Computer-controlled anti-lock braking systems (ABS) are a recently developed safety feature. When sudden stops are made, the ABS prevents wheel lock-up. The system is comprised of wheel-speed sensors that monitor wheel rotation, computer-controlled hydraulics that pulse the brakes on and off rapidly, and the on-board computer.

CV & Drive Axle

The axle on your vehicle is the structural component that connects two wheels together on opposite sites. It's a load-bearing assembly that acts like a central shaft, maintaining the position of the wheels relative to each other and to the vehicle body. The construction of your axle is designed according to what your vehicle is built for; trucks and off-road vehicles are equipped with axles that keep the wheel positions steady under heavy stress (ideal for supporting heavy loads), while conventional axles are constructed for the needs of the general consumer. But no matter what you drive, remember that your vehicle's axle must bear the weight of your vehicle (plus any cargo) and the acceleration forces between you and the ground.

So when it comes to axle inspection, we are a source for professional, knowledgeable service—essential for the equipment that carries you and your family to wherever you need to go.

Simply put, a drive axle is one that is driven by the engine. Typically found in modern front wheel drive vehicles, a drive axle is split between two half axles, with differential and universal joints between them. Each half axle is connected to the wheel by a third joint—the constant velocity (CV) joint—that allows the wheels to move freely. This joint allows the shaft to rotate, transmitting power at a constant speed without a significant increase in friction and heat. CV joints are usually dependable, but, as is the case for all of your vehicle's moving equipment, they do require regular inspection. An easy way for you to tell if you need to see us for axle repair is to go out to a large space (such as a parking lot), and slowly drive in tight circles. If you hear a clicking or cracking noise, you have a worn joint, and it must be repaired immediately.

We will have you back on the road, "click-free" in no time!

Comments are closed.